Installation

Easy-to-follow instructions show you exactly where to place the product on the cold water pipe when using for residential, the same product sold at Home Hardware for reducing fuel cost can also be applied to the cold water pipe.

Placement

PlacementCOLD WATER PIPE

Install one set (two industrial collars) or the single unit sold at Home Hardware on the cold water pipe, after the water meter and before the hot water tank. Always place after any electric ground wire clamp that uses the cold water line for grounding.


Installation

Installation 1STEP 1

Align two units opposing each other (units will repel). Loosely fasten bolt and wing nut through holes on one side of units. Keep loose until step 2 is completed.


Installation 2STEP 2

Place set around pipe and repeat procedure in step 1 on other side. Tighten wing nuts so assembled set is secure and centered along pipe.


Installation for Well Water Lines

Installation for Well Water Lines

Place 2 industrial or 1 Residential Fuel Saver from Home Hardware before the Tee